Removing known bugs

Removed known bug marks from action lines when they are no longer needed.

Ensure that the following requirements are met:

To remove the known bug designation from a given action line:

  1. In the TestArchitect explorer tree, double-click a test module node to open it.

  2. In the test module editor, select an action line that contains a known bug (that is, a yellow dot).

  3. Do one of the following:

    • Click the Remove Known Bug button on the toolbar.
    • Right-click the selected action line, then select Bug > Remove Known Bug
    • Double-click the row header.

After you have removed the known bug mark, the yellow point in the left margin next to the row number you had selected previously disappears.

Note:
Note that this procedure has no effect on the bug itself, only on a line that is marked with it.


Copyright © 2024 LogiGear Corporation. All rights reserved. LogiGear is a registered trademark, and Action Based Testing and TestArchitect are trademarks of LogiGear Corporation. All other trademarks contained herein are the property of their respective owners.

LogiGear Corporation

1730 S. Amphlett Blvd. Suite 200, San Mateo, CA 94402

Tel: +1 (650) 572-1400