Execution log files

Once a harness run completes or is prematurely terminated, its execution information is logged to files.

Note:
Applies to TestArchitect 8.4 and higher.

Log files mostly hold errors and exceptions that occurred during the harness run. All errors and exceptions in log files are described in greater detail than those in the Result Details tab of a test result. So they facilitate debugging or analysis of test results in case of automation errors.

Log files are placed in the following folder:

Important:

Automatically removing old log files
Log files may take up a lot of hard disk space over time. Therefore, TestArchitect offers you a mechanism to automatically delete old log files.

Related information

Automatically removing old log files


Copyright © 2021 LogiGear Corporation. All rights reserved. LogiGear is a registered trademark, and Action Based Testing and TestArchitect are trademarks of LogiGear Corporation. All other trademarks contained herein are the property of their respective owners.

LogiGear Corporation

1730 S. Amphlett Blvd. Suite 200, San Mateo, CA 94402

Tel: +1(800) 322-0333