check

In the general test automation sense, a comparison of a system’s expected behavior with its actual behavior.

In TestArchitect terms, a check is the action performed by one of the family of built-in check… actions (check control exists, check picture, etc.), each of which compares expected vs. actual results, and registers the outcome as a pass or fail in the test result.

Also referred to as: validity check.


Copyright © 2023 LogiGear Corporation. All rights reserved. LogiGear is a registered trademark, and Action Based Testing and TestArchitect are trademarks of LogiGear Corporation. All other trademarks contained herein are the property of their respective owners.

LogiGear Corporation

1730 S. Amphlett Blvd. Suite 200, San Mateo, CA 94402

Tel: +1(800) 322-0333