iOS start program problem: no target application

Problem

Upon completion of an automated test, the following error message is reported in the Automation Problem dialog box, or in the test result:

The start program action could not complete since the target application does not exist on your device.

Solution

Ensure that the application under test is re-signed and installed on your iOS device, then rerun the test.


Copyright © 2023 LogiGear Corporation. All rights reserved. LogiGear is a registered trademark, and Action Based Testing and TestArchitect are trademarks of LogiGear Corporation. All other trademarks contained herein are the property of their respective owners.

LogiGear Corporation

1730 S. Amphlett Blvd. Suite 200, San Mateo, CA 94402

Tel: +1(800) 322-0333