iOS start program problem: device not connected

Problem

Upon completion of an automated test, the following error message is reported in the Automation Problem dialog box, or in the test result:

The start program action could not complete since your device was not connected to the test machine via USB cable.

Solution

Check the USB cable connecting the iOS device to the test controller host. Verify that the connectors are free of debris and that the cable is not damaged. If available, replace with a known good cable.


Copyright © 2024 LogiGear Corporation. All rights reserved. LogiGear is a registered trademark, and Action Based Testing and TestArchitect are trademarks of LogiGear Corporation. All other trademarks contained herein are the property of their respective owners.

LogiGear Corporation

1730 S. Amphlett Blvd. Suite 200, San Mateo, CA 94402

Tel: +1 (650) 572-1400