Save function (Interface Viewer)

Once the proper controls have been named in the tree, and the identifying properties have been selected, you can save the definitions to the interface entity with the Save button.Make sure the interface entity is checked out prior to saving the definitions to it. Saving makes permanent the mappings (or unmappings) you have done in your Interface Viewer session by writing the current configuration to the open interface entity, then saving the interface entity.

  1. Save
  2. Refresh
  3. Identify
  4. Highlight
  5. Auto-highlight
  6. HTML tags filter
  7. Copy value
  8. Capture all controls
  9. UIA support
  10. Activate device mode
  11. Connect to device
  12. Map to unmatched element

The Viewer starts the definition with one or more lines defining settings (properties) for the interface entity itself. In the case of a window, this is typically the title of the window.

In addition, the saved interface entity has an interface element line for each control, of which the argument list starts with the ta name and ta class properties, followed by the identifying properties you have selected for the element. The following figure demonstrates how each a typical interface element is saved:


Copyright © 2024 LogiGear Corporation. All rights reserved. LogiGear is a registered trademark, and Action Based Testing and TestArchitect are trademarks of LogiGear Corporation. All other trademarks contained herein are the property of their respective owners.

LogiGear Corporation

1730 S. Amphlett Blvd. Suite 200, San Mateo, CA 94402

Tel: +1 (650) 572-1400