Setting a default interface

The default interface in a project is the one that is in effect during a test if no other interface has been specified for the test. (Typically, however, a test initializes itself with the use interface built-in action to specify the interface to be used).

Choose one of the following three methods to set a default interface:

The icon for the interface that has been set as default displays a red horizontal bar across the top.

Copyright © 2023 LogiGear Corporation. All rights reserved. LogiGear is a registered trademark, and Action Based Testing and TestArchitect are trademarks of LogiGear Corporation. All other trademarks contained herein are the property of their respective owners.

LogiGear Corporation

1730 S. Amphlett Blvd. Suite 200, San Mateo, CA 94402

Tel: +1(800) 322-0333