Mapping TestArchitect test modules to Zephyr test cases

Apart from TestArchitect test cases, you can map TestArchitect test modules to Zephyr test cases.

Notes: 
Applies to TestArchitect 8.4 Update 3 and higher

Remember: 
Each Zephyr test case can only be mapped to a single TestArchitect test module.

Ensure that you have already taken the following steps:

Via Test module list view

  1. In the TestArchitect explorer tree, double-click the test node that contains the test module to be mapped.

  2. On the Test Modules tab, double-click the preferred source ID in the Source column.

  3. Type/change the source ID. Press Enter.

Via the Source field on the Information tab

  1. Open the test module to be mapped.
  2. On the Information tab, type/change the source ID in the Source field. Click the Apply button.

Copyright © 2024 LogiGear Corporation. All rights reserved. LogiGear is a registered trademark, and Action Based Testing and TestArchitect are trademarks of LogiGear Corporation. All other trademarks contained herein are the property of their respective owners.

LogiGear Corporation

1730 S. Amphlett Blvd. Suite 200, San Mateo, CA 94402

Tel: +1 (650) 572-1400