Mapping test results between TestArchitect and Azure DevOps Services

This section describes possible test results mappings between TestArchitect and ADO when TestArchitect test results are uploaded into ADO.These are options that you set in the TEST MANAGEMENT window of TestArchitect’s Azure DevOps Services external tool.

NoTA test statusADO test status
1PassedPassed (default)
Failed
Inconclusive

2FailedPassed
Failed (default)
Inconclusive

3Passed with Warning/ErrorPassed
Failed (default)
Inconclusive

4Passed with Known BugPassed
Failed (default)
Inconclusive

5Not Finished 1Passed
Failed
Inconclusive (default)

6Not Run 2Passed
Failed
Inconclusive (default)

重要: 

1 Not Finished occur if a test is started, but it is unable to reach the end of an automated run. An unfinished test case may result from any one of the following:

2 Not Run occurs when a test case is not even started.

ADO: Azure DevOps


Copyright © 2024 LogiGear Corporation. All rights reserved. LogiGearはLogiGear Corporationの登録商標であり、Action Based TestingおよびTestArchitectはLogiGear Corporationの商標です。ここに記載されているその他の商標は、各所有者の財産です。

LogiGear Corporation

1730 S. Amphlett Blvd. Suite 200, San Mateo, CA 94402

Tel: +1 (650) 572-1400