ユーザーガイド Controller management

 Starting TestArchitect Controller from a command line interface

Starting TestArchitect Controller from a command line interface

you are able to start TestArchitect Controller with a new port from a command line interface using either TAController or TACTRL command.

TAController vs TACTRL

The usage of both commands is to launch TestArchitect Controller. They are placed in the same location:

• On Windows: <TA_INSTALL_DIR>\controller.
• On Linux: /usr/local/logigear/testarchitect/controller.
• On macOS: /Applications/TestArchitect/controller

A sharp distinction between the two commands is their behavior towards the console prompt. Upon a successful execution, the TAController command will return the console prompt. On contrary, upon a successful execution, the TACTRL command will keep the console prompt. Therefore, TAController, not TACTRL, suits CI/CD testing.

Using the TAController command

1. Launch a command line.

2. Browse to the folder where the TAController command is located.

3. Run the following command:

   • On Windows: TAController.exe [-port <port_number>]

     For example, TAController.exe -port “53632”

   • On Linux: TAController.sh [-port <port_number>]

   • On macOS: TAController.sh [-port <port_number>] Where -port: assigns a port number to TestArchitect Controller.

   覚えておく: 
   The port number of TestArchitect Controller must fall within a range of 53600 to 53699.

Using the TACTRL command

1. Launch a command line.

2. Browse to the folder where the TACTRL command is located.

3. Run the following command:

   • On Windows: TACTRL.exe [-port <port_number>]

     For example, TACTRL.exe -port “53641”

   • On Linux: TACTRL.sh [-port <port_number>]

   • On macOS: TACTRL.sh [-port <port_number>]

   Where -port: assigns a port number to TestArchitect Controller.

   覚えておく: 
   The port number of TestArchitect Controller must fall within a range of 53600 to 53699.