No window found matching <windowName> within the timeout of <value> seconds. Please check the interface definition for <windowName>, or set a longer timeout with the 'window wait' setting.

Error code: 0x80010004L

Common causes

AUT change issue, that is when title of the window is changed.
Timing issue, that is when the window is not available within a specified timeout, defined in the window wait built-in setting.
Scripting issue means improper interface, or improper definition/invalid syntax of dynamic identifier.

You can apply the following ways to troubleshoot why the window could not be found:

If the AUT is open, check whether the title of the window is changed.
- In the Viewer, if the window is unmatched, see the Property Comparison panel to understand why the window is no longer matched. You might need to recapture the interface definition of the window.
- In the Viewer, if the window is matched, it might be timing or scripting issue. You might need to modify your test procedures.
  - Use Screenshot Recording: You have an instant view of the state of the system at each critical juncture, and instantly know if that state was as expected.
  - Adjust higher wait time value of the window wait built-in setting.
  - Verify whether the correct interface is currently used.
If the AUT is not available within a given timeout, it might be timing issue. Try adjusting higher wait time value of the window wait built-in setting.