click method

Description

Specifies which type of sendInput() message – that is, separate sendinput messages or single sendinput message – takes effect when TestArchitect performs click-related built-in actions on the AUT.

Allowable values

注意: 

Technically, in TestArchitect, when a mouse click is specified by an action or method, the following three events are triggered in sequence:

  1. MouseMove: Move the mouse pointer to the specified coordinate.
  2. MouseDown: Press the mouse button.
  3. MouseUp: Release the mouse button.

Default value

single sendinput message

Applicable Systems/Platforms

This built-in setting is supported on the following systems/platforms:

Applicable Built-in Actions

Use of this built-in setting is applicable to the following built-in actions:

Notes

Example

By default, the click method setting holds a value of single sendinput message. System issues such as unstable networks, poor remote desktop connections, etc., can cause click-related built-in actions to unexpectedly fail to register with the AUT during automation. Changing the value of this setting to separate sendinput messages is one means of addressing this issue.

Note that use of the value separate sendinput messages ensures that a certain delay exists between submissions of the MoveMouse, MouseDown and MouseUp. You can further control the delay between the MouseDown and MouseUp messages by means of the built-in setting click delay.

Related information

click delay

enable click hook


Copyright © 2024 LogiGear Corporation. All rights reserved. LogiGearはLogiGear Corporationの登録商標であり、Action Based TestingおよびTestArchitectはLogiGear Corporationの商標です。ここに記載されているその他の商標は、各所有者の財産です。

LogiGear Corporation

1730 S. Amphlett Blvd. Suite 200, San Mateo, CA 94402

Tel: +1 (650) 572-1400