Mapping TA test modules to TFS test cases

In addition to TestArchitect test cases, you can map TestArchitect test modules to TFS test cases.

Note:
Applies to TestArchitect 8.4 Update 1 and higher.

Remember:
The ID of each TFS test case can only be mapped to a single TestArchitect test module.

  1. In the TestArchitect explorer tree, double-click the test node that contains the test module to be mapped

  2. On the Test Modules tab, double-click the preferred source ID in the Source column.

  3. Type/Change the source ID. Press Enter

Fastpath: you can quickly map a TestArchitect test module to a TFS test case in the Source field on the Information tab of the test module.


Copyright © 2024 LogiGear Corporation. All rights reserved. LogiGear is a registered trademark, and Action Based Testing and TestArchitect are trademarks of LogiGear Corporation. All other trademarks contained herein are the property of their respective owners.

LogiGear Corporation

1730 S. Amphlett Blvd. Suite 200, San Mateo, CA 94402

Tel: +1 (650) 572-1400