Comparing results with baseline

Side-by-side comparison can be made between a test result and a baseline result. Both results must be for the same test module or test module variation.

Ensure that you meet the following requirements before comparing test results to a baseline:

Choose one of the following two methods to compare the test results against the baseline results:

The Result Comparison dialog box appears to show the differences at checkpoints in the test results. See Results Comparison dialog boxes for an explanation of the Results Comparison dialog box.

Note:
If the test result is from a set of serial test results, the Comparing Multiple Pairs of Results dialog box appears. See Comparing serial run results for an explanation of the Comparing Multiple Pairs of Results dialog box.

Related tasks

Setting baseline result

Unsetting baseline results

Comparing results without baseline


Copyright © 2024 LogiGear Corporation. All rights reserved. LogiGear is a registered trademark, and Action Based Testing and TestArchitect are trademarks of LogiGear Corporation. All other trademarks contained herein are the property of their respective owners.

LogiGear Corporation

1730 S. Amphlett Blvd. Suite 200, San Mateo, CA 94402

Tel: +1 (650) 572-1400