Troubleshooting device registration

This topic lists typical issues you may experience when registering devices to a Lab Manager session, and offers possible solutions.

You do not see the desired device on the Add new Device dialog box

If you do not see the device you want to register in Lab Manger, there are two most likely reasons:

  1. The device is not connected to its host controller.

    Check the connection between the device and its host controller, and then reattempt to register that device in your Lab Manager session.

  2. The desired device is already registered to your Lab Manager session.


Copyright © 2024 LogiGear Corporation. All rights reserved. LogiGear is a registered trademark, and Action Based Testing and TestArchitect are trademarks of LogiGear Corporation. All other trademarks contained herein are the property of their respective owners.

LogiGear Corporation

1730 S. Amphlett Blvd. Suite 200, San Mateo, CA 94402

Tel: +1 (650) 572-1400