Debugging in a remote desktop session

How to debug a harness in a remote desktop session.

Note:
Applies to TestArchitect 8.4 Update 3

You are knowledgeable about test runs in multiple remote desktop sessions

Restriction:
You are unable run in the debugging mode on more than one remote desktop session.

  1. Create a remote desktop session with a preferred user account. Start TestArchitect Controller.

  2. On your local computer,

    1. In the TestArchitect explorer tree, select the test module/suite to be debugged, and press Ctrl + F9 to invoke the Execute Test dialog box.

    2. Open the Select Controller/Device dialog box, add the controller of the remote desktop session. Select the checkbox for the controller. Click OK.

    3. In the Execute Test dialog box, click the Compile Only button.

  3. On the remote desktop session, create the TA_RUN_CONFIG environment variable with the value C:\Users\<User Name>\LogiGear\TestArchitect\controller\requests\run.dat

    Important:
    this step needs carrying out for the first time only.

  4. Execute the taplayback.exe command located in {TA_INSTALL_DIR}\binclient so as to start debugging the harness


Copyright © 2024 LogiGear Corporation. All rights reserved. LogiGear is a registered trademark, and Action Based Testing and TestArchitect are trademarks of LogiGear Corporation. All other trademarks contained herein are the property of their respective owners.

LogiGear Corporation

1730 S. Amphlett Blvd. Suite 200, San Mateo, CA 94402

Tel: +1 (650) 572-1400