page wait state

Description

Specifies whether the page wait built-in setting applies to the complete loading of a web page, or to the loading of a page only up to the point where it is in an interactive state.

Allowable Values

Default Value

complete

Applicable Systems/Platforms

Use of this built-in setting is supported on the following systems/platforms: Internet Explorer.

Notes

Example

Suppose that in test case TC 01 you only want to wait until a page finishes loading interactively, so that you can access the DOM elements quickly, including username and password controls. By contrast, in test case TC 02, in order to verify CSS files applied to the given page, your test must wait until a page finishes loading fully.

Action Lines


Copyright © 2024 LogiGear Corporation. All rights reserved. LogiGear is a registered trademark, and Action Based Testing and TestArchitect are trademarks of LogiGear Corporation. All other trademarks contained herein are the property of their respective owners.

LogiGear Corporation

1730 S. Amphlett Blvd. Suite 200, San Mateo, CA 94402

Tel: +1 (650) 572-1400