enable click hook


Specifies whether, after a click-related built-in action is executed and fails to register, a second attempt is made with the hook mechanism enabled. (Learn more.) Enabling of hook helps ensure a successful click.

Allowable values

Default value


Applicable Systems/Platforms

Use of this built-in setting is supported on the following systems/platforms:

Applicable Built-in Actions

Use of this built-in setting is applicable to the following built-in actions:



Under various test environment conditions, your click-related built-in actions may fail to properly register with the AUT. Setting enable click hook to yes directs TestArchitect to re-execute such built-in actions when they do fail, in each case with the hook mechanism enabled on the subsequent attempt.

Related information

click delay

click method

Copyright © 2021 LogiGear Corporation. All rights reserved. LogiGear is a registered trademark, and Action Based Testing and TestArchitect are trademarks of LogiGear Corporation. All other trademarks contained herein are the property of their respective owners.

LogiGear Corporation

1730 S. Amphlett Blvd. Suite 200, San Mateo, CA 94402

Tel: +1(800) 322-0333