wait for control not exists


Allow for execution to proceed only when it is determined that a specified control no longer exists.


Valid contexts

This action may be used within the following project items: test modules and user-defined actions.


Applicable Built-In Settings

The following settings are applicable to this action: case sensitive, load invisible controls, object wait, remove double quotes from cells, standard ASCII only, page wait, window wait.


Your test instructs the AUT to save a given working document. You do not want to allow the test to continue until the save operation is complete, hence you can use the presence (or absence) of the Saving progress bar to indicate that the save is ongoing (or complete).

Action Lines

Copyright © 2021 LogiGear Corporation. All rights reserved. LogiGear is a registered trademark, and Action Based Testing and TestArchitect are trademarks of LogiGear Corporation. All other trademarks contained herein are the property of their respective owners.

LogiGear Corporation

1730 S. Amphlett Blvd. Suite 200, San Mateo, CA 94402

Tel: +1(800) 322-0333