verify mode

A mode set by the built-in verify picture setting. Under verify mode, unverified picture checks produced during a test run are automatically displayed in sequence at the end of the run, allowing a user to manually resolve the Pass, Fail, or Warning status of each.


Copyright © 2024 LogiGear Corporation. All rights reserved. LogiGear is a registered trademark, and Action Based Testing and TestArchitect are trademarks of LogiGear Corporation. All other trademarks contained herein are the property of their respective owners.

LogiGear Corporation

1730 S. Amphlett Blvd. Suite 200, San Mateo, CA 94402

Tel: +1 (650) 572-1400