non-verify mode

A mode set by the built-in verify picture setting. Under non-verify mode, the display of unverified picture checks produced during a test run is suppressed at the end of the run. Instead, user may manually retrieve unverified picture checks relating to the test run at any later time, in order to resolve their respective Pass, Fail, or Warning statuses.


Copyright © 2024 LogiGear Corporation. All rights reserved. LogiGear is a registered trademark, and Action Based Testing and TestArchitect are trademarks of LogiGear Corporation. All other trademarks contained herein are the property of their respective owners.

LogiGear Corporation

1730 S. Amphlett Blvd. Suite 200, San Mateo, CA 94402

Tel: +1 (650) 572-1400